![]() You should hear a “click” sound, which indicates that the spark has ignited the pilot. Hold the gas control knob or pilot set button and simultaneously press the piezo igniter.Turn the knob back to the Pilot position.Wait for a while to let the gases clear from the lines.Turn the control knob to the OFF position, and if required, push it down to switch from Pilot to OFF.Adjust the thermostat to the lowest setting.However, the most common procedure for lighting a gas water heater pilot light is as follows: Therefore, you should always consult the instructions provided by the manufacturer. The method for properly lighting a pilot light varies depending on the type of water heater you have. If you have an electronic ignition system on your gas water heater, you should not attempt to light it by hand. How to Light a Gas Water Heater Pilot Light To solve this problem, hold down the pilot knob for a little longer to expel the air from the line. If your water heater is newly installed, there might be air in the gas line. If you suspect this is the issue, you’ll need to contact a water heater repair expert or your gas company for assistance. Low gas pressure or a defective gas control valve can lead to the pilot light frequently going out.The thermocouple is responsible for detecting the pilot flame, and if it doesn’t detect any flame, it stops the ignition process, and the burner won’t light. The thermocouple might be damaged or faulty.To fix it, ensure that the valve is open by making sure that the handle is parallel to the pipe. The gas valve on the gas supply pipe may be closed.If you have a spark but the pilot light won’t light up, it indicates that gas is not flowing to the pilot. Video: How to Fix if Water Heater Igniter Won’t Spark ![]() Use a dry cloth and sandpaper to clean the tip of the electrode and remove any debris, rust, or dirt.
0 Comments
Leave a Reply. |